What the Food Standards Code requires

Clean first, then sanitise

FSANZ separates the two jobs. Cleaning removes dirt, grease and food waste. Sanitising destroys microorganisms, and it is done after cleaning. The routine on the FSANZ page is to scrape or wipe off food scraps and rinse, wash with hot water and detergent, rinse off the detergent, then sanitise, and air dry where you can.

Standard 3.2.2 requires the business to keep premises, fixtures, fittings, equipment and food transport vehicles clean and sanitary. Clause 20, as set out in the FSANZ guide to Standard 3.2.2A, requires eating and drinking utensils to be clean and sanitary immediately before each use, and food contact surfaces to be clean and sanitary whenever food that will touch them is likely to be contaminated.

Ways FSANZ sets out to sanitise

The FSANZ cleaning and sanitising page lists these options:

  • Very hot water at 77°C for 30 seconds
  • Diluted bleach
  • 70% isopropyl alcohol or ethanol
  • A commercial sanitiser used to the manufacturer's instructions, or a dishwasher that can sanitise

For bleach, FSANZ suggests 100 ppm chlorine in cold water and 50 ppm in warm water. Contact time is usually 10 to 30 seconds, and the instructions on the product should be checked. Diluted bleach is thrown away after 24 hours. Use plain bleach, free from fragrances and other additives, to reduce the chance of tainting. For a dishwasher, FSANZ says to use the longest, hottest cycle, or the program designed for sanitation, and to follow the manufacturer's instructions.

Suitable for food contact surfaces

Safe Food Australia says chemicals used on food contact surfaces and eating utensils should be suitable for that use. It names chlorine compounds, quaternary ammonium compounds, alcohol, iodophors, peracetic acid and hydrogen peroxide as traditional sanitisers. Vinegar, lemon juice and methylated spirits are not generally recommended unless the method, including concentration, temperature and contact time, has been validated. Some chemicals can leave residues that taint food. Products made for floors and toilets are generally not suitable for food contact surfaces.

Standard 3.2.2A: showing that cleaning and sanitising happened

Standard 3.2.2A applies in Australia to food service, catering and retail businesses that handle unpackaged potentially hazardous food that is ready to eat. A note in the standard says it becomes enforceable from December 2023. It does not apply in New Zealand. Category one businesses must use all three tools: food handler training, a food safety supervisor, and records or other evidence. Category two businesses must have a food safety supervisor and trained food handlers. They are not required to make the evidence records.

A food safety supervisor holds a certificate issued within the past 5 years by a registered training organisation, or by an organisation recognised by the relevant authority, and has authority to direct safe food handling. Food handler training includes cleaning and sanitising of the premises and equipment.

The evidence tool covers temperature control, processing, and cleaning and sanitising. For cleaning and sanitising, the FSANZ guide says the record should show:

  • If heat is used, the water temperature reached, and the date
  • If chemicals are used, how and when they are used on food contact surfaces, and the date
  • If a commercial dishwasher is used, the manufacturer's recommended sanitising setting

The suggested frequency is daily, or as often as the procedure says. Clause 12 requires a record that is made under the evidence tool to be kept for at least 3 months. A record can be a validated procedure, data logger output, or photos or video, if an authorised officer can see it. The business must make a record unless it can show in another way that it is complying.

For a buyer, a sanitiser with vague instructions makes that record harder to write. Choose a product whose label states the dilution, contact time and, where it matters, the water temperature, so the procedure can quote them.

Safety data sheets, labels and registers

Cleaning chemicals are also workplace chemicals. In Australia, a person conducting a business that stores, handles or uses hazardous chemicals must keep a register at the workplace. The register includes the current safety data sheet for each hazardous chemical and must be readily accessible to workers and to emergency services. It does not have to list chemicals that are not classified as hazardous, or a hazardous chemical bought and used as a consumer product where a safety data sheet is not required.

Since 1 January 2023, hazardous chemicals must be classified and labelled under GHS 7. A safety data sheet kept at the workplace must comply with GHS 7 from that date, even if the label on older stock does not. Stock manufactured or imported before 1 January 2023 may still carry a GHS 3 label. Stock manufactured or imported on or after that date, and accepted into the workplace, must be labelled under GHS 7 and have a GHS 7 safety data sheet.

In New Zealand, WorkSafe requires a current safety data sheet for each hazardous substance, regardless of quantity. The business must obtain one when the substance is first supplied, which includes the first supply to that workplace in five years, and when the sheet is amended. A consumer product used in quantities and ways consistent with household use is an exception. Each site needs its own inventory of hazardous substances, kept up to date and available to emergency services. The inventory includes a current safety data sheet or a short version of the key information. Businesses that make or sell higher-risk food use a food control plan under the Ministry for Primary Industries to set out how food safety risks are managed, so the cleaning method belongs in that plan.

For diluted bleach, note the day it was made up, because it is thrown out after 24 hours. When the product changes, get the new safety data sheet before it is used.

A cleaning chemical specification checklist

Product

  • Whether the product is a detergent, a sanitiser, or both, and the active ingredient
  • A statement that it is suitable for food contact surfaces
  • Dilution, water temperature and contact time, printed on the label
  • Whether a rinse is needed after sanitising
  • Whether it suits the dishwasher and any dosing equipment

Documents

  • A current GHS 7 safety data sheet for Australia, or an HSNO-compliant safety data sheet for New Zealand
  • The product name and the supplier's name on the label
  • A batch number and an expiry date, where the product has them
  • Traceability for each batch. Quality documents belong to the manufacturer. Shiiv Imports holds ISO 9001.

Storage and supply

  • A pack size that suits the store and the dosing equipment
  • Storage and segregation from the safety data sheet, away from food
  • Lead time and an approved second product

The chemical sits next to other hygiene items. See the guides to disposable food gloves and napkins and food-hygiene tissue. Where cleaning meets allergens, see the allergen labelling guide.

Our take

Sanitiser is a small line with a large compliance footprint. Choose products with clear dilution and contact time, a current safety data sheet, and a label the team can follow. Use one specification across sites, write the method into the procedure, and keep the record Standard 3.2.2A requires of a category one business.

QSR Supplier does not manufacture cleaning chemicals, and they are not a listed line. Shiiv sources food, packaging and hygiene lines to a buyer's brief. Shiiv Imports holds ISO 9001. Manufacturer documents belong to the manufacturer. See what we source and the food packaging and napkins page. To put hygiene items on a brief, send a chain brief or talk to our team.

Frequently asked questions

What is the difference between cleaning and sanitising?

Cleaning removes dirt, grease and food waste. Sanitising destroys microorganisms. FSANZ says items need to be cleaned before they are sanitised.

What temperature sanitises utensils without chemicals?

FSANZ gives very hot water at 77°C for 30 seconds. A dishwasher that can sanitise is another option. FSANZ says that is usually the longest, hottest setting, or the program designed for sanitation.

How strong should bleach be for sanitising food surfaces?

FSANZ suggests 100 ppm chlorine in cold water and 50 ppm in warm water. Contact time is usually 10 to 30 seconds, and the product instructions should be checked. Use plain bleach, free from fragrances and other additives, and throw the diluted solution away after 24 hours.

Do QSR stores need to keep cleaning and sanitising records?

Category one businesses under Standard 3.2.2A must make a record that shows cleaning and sanitising, unless they can show compliance another way. A required record must be kept for at least 3 months. The FSANZ guide suggests making it daily, or as often as the procedure says. A record can be a validated procedure, data logger output, or photos or video, if an officer can see it. Category two businesses are not required to make these records. The standard applies in Australia and does not apply in New Zealand.

Do I need a safety data sheet for every cleaning chemical?

In Australia, a workplace that stores, handles or uses hazardous chemicals must keep a register with the current safety data sheet for each one, readily accessible to workers and emergency services. The register does not have to include chemicals that are not classified as hazardous, or a hazardous chemical bought and used as a consumer product where a safety data sheet is not required. In New Zealand, a current safety data sheet is required for each hazardous substance regardless of quantity, except a consumer product used in quantities and ways consistent with household use. A commercial pack used in a store should not be assumed to fall under that exception. Obtain the sheet when the product is first supplied, if that is the first supply to the workplace in five years, or when the sheet is amended.

Can I use vinegar or methylated spirits as a sanitiser?

FSANZ does not generally recommend vinegar, lemon juice or methylated spirits unless the method, including concentration, temperature and contact time, has been validated. Chemicals used on food contact surfaces should be suitable for that use. Products made for floors and toilets are generally not suitable for food contact surfaces.

Sources

This guide summarises public regulator information current at 30 October 2026. Standards 3.2.2 and 3.2.2A are Australian food safety standards and do not apply in New Zealand. It is general information, not legal, food safety or work health and safety advice. Requirements can vary by state, territory and council. Confirm them with your food regulator, your work health and safety regulator, your food safety adviser and your suppliers.